Alcatel-Lucent 7750 SR OS Basic User Manual

Show Commands
Page 198 7750 SR OS Basic System Configuration Guide
Sample Output
A:ALA-1# show bof cf3:
=====================================================================
BOF on cf3:
=====================================================================
autonegotiate
primary-image ftp://test:test@192.168.xx.xx/./both.tim
primary-config ftp://test:test@192.168.xx.xx/./1xx.cfg
secondary-image cf1:/i650/
secondary-config cf1:/config.cfg
address 192.168.xx.xxx/20 active
address 192.168.xx.xxx/20 standby
primary-dns 192.168.xx.xxx
dns-domain test.test.com
autonegotiate
duplex full
speed 100
persist
on — Persistent indexes between system reboots is enabled.
off — Persistent indexes between system reboots is disabled.
wait
The time configured for the boot to pause while waiting for console
input.
autonegotiate
No autonegotiate — Autonegotiate not enabled.
autonegotiate — Autonegotiate is enabled.
duplex
half — Specifies that the system uses half duplex.
full — Specifies that the system uses full duplex.
speed
The speed of the CPM Ethernet interface.
console speed
The console port baud rate.
dns domain
The domain name used when performing DNS address resolution.
uplinkA-address
Displays the Uplink-A IP address.
uplinkA-port
Displays the primary port to be used for auto-boot.
uplinkA-route
Displays the static route associated with Uplink-A.
uplinkA-vlan
Displays the VLAN ID to be used on Uplink-A.
uplinkB-address
Displays the Uplink-B IP address.
uplinkB-port
Displays the secondary port to be used for auto-boot.
uplinkB-route
Displays the static route associated with Uplink-B.
uplinkB-vlan
Displays the VLAN ID to be used on Uplink-B.
Table 25: Show BOF Output Fields (Continued)
Label Description

Alcatel-Lucent 7750 SR OS Basic Specifications

General

Brand	Alcatel-Lucent
Model	7750 SR OS Basic
Category	Network Router
Language	English