System Information Commands
Page 328 7750 SR OS Basic System Configuration Guide
Parameters location — Enter the location as a character string. The string may be up to 80 characters long. Any
printable, seven-bit ASCII characters can be used within the string. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
name
Syntax name system-name
no name
Context config>system
Description This command creates a system name string for the device.
For example, system-name parameter ALA-1 for the name command configures the device name as
ALA-1.
ABC>config>system# name "ALA-1"
ALA-1>config>system#
Only one system name can be configured. If multiple system names are configured, the last one
encountered overwrites the previous entry.
The no form of the command reverts to the default value.
Default The default system name is set to the chassis serial number which is read from the backplane
EEPROM.
Parameters system-name — Enter the system name as a character string. The string may be up to 32 characters
long. Any printable, seven-bit ASCII characters can be used within the string. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed within double
quotes.
switchover-exec
Syntax switchover-exec file-url
no switchover-exec
Context config>system
Description This command specifies the location and name of the CLI script file executed following a redundancy
switchover from the previously active CPM card. A switchover can happen because of a fatal failure
or by manual action.
The CLI script file can contain commands for environment settings, debug and mirroring settings,
and other commands not maintained by the configuration redundancy.
When the file-url parameter is not specified, no CLI script file is executed.
Default none
Parameters file-url — Specifies the location and name of the CLI script file.
To Next Page
Loading...
Need help?
General
