System Management
7750 SR OS Basic System Configuration Guide Page 393
MC Endpoint Commands
mc-endpoint
Syntax [no] mc-endpoint
Context config>redundancy>multi-chassis>peer
Description This command specifies that the endpoint is multi-chassis. This value should be the same on both
MC-EP peers for the pseudowires that must be part of the same group.
The no form of this command removes the endpoint from the MC-EP. Single chassis behavior
applies.
bfd-enable
Syntax [no] bfd-enable
Context config>redundancy>multi-chassis>peer>mc-ep
config>router>rsvp
config>router>bgp
config>router>bgp>group
config>router>bgp>group>neighbor
config>redundancy>multi-chassis>peer>mc-ep
Description This command enables the use of bi-directional forwarding (BFD) to control the state of the
associated protocol interface. By enabling BFD on a given protocol interface, the state of the protocol
interface is tied to the state of the BFD session between the local node and the remote node. The
parameters used for the BFD are set via the BFD command under the IP interface.
The no form of this command disables BFD.
Default no bfd-enable
boot-timer
Syntax boot-timer interval
no boot-timer
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command configures the boot timer interval. This command applies only when the node reboots.
It specifies the time the MC-EP protocol keeps trying to establish a connection before assuming a
failure of the remote peer. This is different from the keep-alives mechanism which is used just after
the peer-peer communication was established. After this time interval passed all the mc-endpoints
configured under services will revert to single chassis behavior, activating the best local PW.
To Next Page
Loading...
Need help?
General
