Alcatel-Lucent 7750 SR OS Basic - Page 400

Redundancy Commands
Page 400 7750 SR OS Basic System Configuration Guide
path-excl
Syntax [no] path-excl
Context config>redundancy>mc>peer>mcr>ring
Description This command specifies the set of upper-VLAN IDs associated with the SAPs that are to be excluded
from control by the multi-chassis ring.
Default If not specified, the default is an empty set.
ring-node
Syntax ring-node ring-node-name [create]
no ring-node ring-node-name
Context config>redundancy>mc>peer>mcr>ring
Description This command specifies the unique name of a multi-chassis ring access node.
Parameters ring-node-name — Specifies the unique name of a multi-chassis ring access node.
create — Keyword used to create the ring node instance. The create keyword requirement can be
enabled/disabled in the environment>create context.
connectivity-verify
Syntax connectivity-verify
Context config>redundancy>mc>peer>mcr>ring>ring-node
Description This command enables the context to configure node connectivity check parameters.
dst-ip
Syntax dst-ip ip-address
no dst-ip
Context config>redundancy>mc>peer>mcr>ring>ring-node>connectivity-verify
Description This command configures the node cc destination IP address.
Default no dst-ip
Parameters ip-address — Specifies the destination IP address used in the inband control connection.