Tools Commands
Page 470 7750 SR OS Basic System Configuration Guide
peer sys id : 00:03:fa:c6:31:f8
master : No
conf boot timer : 300
boot timer active : No
conf ka intv : 10
conf hold on num of fail : 3
tlv own ka intv : 10
tlv peer ka intv : 10
ka timeout tmr active : Yes
ka timeout tmr intvl : 20
ka timeout tmr time left : 4
peer ka intv : 10
mc peer timed out : No
initial peer conf rx : Yes
peer-mc disabled : No
initial peer conf sync : Yes
peer conf sync : Yes
own passive mode : Disable
peer passive mode : No
retransmit pending : No
non-mcep retransmit pending : No
retransmit intvl : 5
last tx time : 1437130
last rx time : 1437156
own bfd : Enable
peer bfd : Enable
bfd vrtr if : 2
bfd handle : 1
bfd state : 3
bfd code : 0
*A:Dut-B#
mc-ring
Syntax mc-ring
mc-ring peer ip-address [ring sync-tag]
Context tools>dump>redundancy>multi-chassis
Description This command dumpsmulti-chassis ring information.
peer ip-address — Specifies the peer’s IP address.
ring sync-tag — Specifies the ring’s sync-tag created in the config>redundancy>mc>peer>mcr>
ring context.