Root Commands
7750 SR OS Basic System Configuration Guide Page 91
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
subscriber
Syntax subscriber sub-ident-string [arbiter name | root] [ingress | egress] [interval seconds]
[repeat repeat] [absolute | rate]
Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics for a subscriber.
Parameters sub-ident-string — Specifies an existing subscriber a identification policy name.
arbiter name — Specify the name of the policer control policy arbiter.
Values An existing scheduler-name in the form of a string up to 32 characters long com-
posed of printable, 7-bit ASCII characters. If the string contains special characters
(#, $, spaces, etc.), the entire string must be enclosed within double quotes.
root — Specify the scheduler to which this queue would be feeding.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
To Next Page
Loading...
