Monitor CLI Commands
Page 94 7750 SR OS Basic System Configuration Guide
subscriber
Syntax subscriber sub-ident-string [scheduler scheduler-name] [ingress | egress] [interval
seconds] [repeat repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
Description This command monitors cheduler statistics for a subscriber.
Parameters sub-ident-string — Specifies an existing subscriber a identification policy name.
scheduler scheduler-name — Specify an existing QoS scheduler policy name. Scheduler names are
configured in the config>qos>scheduler-policy>tier level context.
Values An existing scheduler-name in the form of a string up to 32 characters long com-
posed of printable, 7-bit ASCII characters. If the string contains special characters
(#, $, spaces, etc.), the entire string must be enclosed within double quotes.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
router
Syntax router router-instance
Context monitor
Description This command enables the context to configure criteria to monitor statistical information for BGP,
LDP, MPLS, OSPF, OSPF3, PIM, RIP, and RSVP protocols.
Parameters router-instance — Specify the router name or service ID.
Values router-name: Base, management
service-id: 1 — 2147483647
Default Base
To Next Page
Loading...
