Alcatel-Lucent ALE M3 - Page 14

ALE M3-M5-M7-M8 DeskPhones Administrator Guide
14
Parameter
SettingSntpServer
config.xml
Description
It configures the primary NTP server.
Permitted
Values
IPv4 Address
Default
0.pool.ntp.org
Web UI
Setting → Time & Date → SNTP Address
Parameter
SettingSntpServer2
config.xml
Description
It configures the secondary NTP server.
Permitted
Values
IPv4 Address
Default
time.nist.gov
Web UI
Setting → Time & Date → SNTP Secondary Address
2.2.4 DHCP Option 12
You can specify a hostname for the phone when using DHCP. The DHCP client uses option 12 to send a
predefined hostname to the DHCP registration server. The name may or may not be qualified with the local
domain name (based on RFC 2132). See RFC 1035 for character phone restrictions.
2.2.5 DHCP Option 132
The ALE Myriad Series phones support configuring DHCP option 132 to define 802.1Q VLAN ID.
2.2.6 DHCP Option 133
The ALE Myriad Series phones support configuring DHCP option 133 to define 802.1p LAYER 2 priority for
SIP/RTP.
2.2.7 DHCP Option 100
The IP phones support configuring DHCP option 100 to define time zone.
The format of the POSIX specifier is <name><offset><dst name><dst offset><dstrule>
• <name> is the name of the timezone when not in daylight savings (e.g., GMT, PST, NZST)
• <offset> is the offset added to the local time to get UTC, specified as [+|-]hh[:mm[:ss]] (eg 0, 8, -12)
• <dst name> is the name of the timezone when in daylight savings (eg BST, PDT, NZDT)
• <dst offset> is the offset added to the local time to get UTC during daylight savings, similarly
specified as [+|-]hh[:mm[:ss]]
Examples:
• London: GMT0BST1,M3.5.0/1:00:00,M10.5.0/2:00:00
• Los Angeles: PST8PDT,M3.2.0/2:00:00,M11.1.0/2:00:00
• New Zealand: NZST-12NZDT,M9.5.0/2:00:00,M4.1.0/3:00:00
2.2.8 VCI Definition
You can define the VCI by the parameter below in the configuration file:
Parameter
DeviceNetworkVciValue
config.xml
Description
It configures the phone VCI information.