Alcatel-Lucent ALE M3 - Page 145

ALE M3-M5-M7-M8 DeskPhones Administrator Guide
145
CALLEND
End a call
ASW/CANCEL/HOLD/UNHOLD:xxx
Answer/end/hold/unhold a call (xxx refers to the call-id of
the active call)
AlwaysFwdOn/BusyFwdOn/NoAnswFwdOn
=xxx
Activate an always/busy/no answer forward feature to xxx
for the IP phone (“xxx” means the destination number)
AlwaysFwdOff/BusyFwdOff/NoAnswFwdOff
Deactivate the always/busy/no answer forward feature for
the IP phone
number=xxx&outgoing_uri=y
Use y call to xxx
Eg:
https://10.4.0.62/servlet?key=number=1000&outgoing_uri=
1001
Use 1001 call 1000
Autop
Perform auto provisioning
screencapture
Gets the current screen capture
Eg:
https://10.4.0.62/screencapture
https://10.4.0.62/servlet?command=screencapture
If you want to download screen shots
https://10.4.0.62/screencapture/download
10.27.4 Action URI Configuration
The following table lists the parameters you can use to configure action URI.
Parameter
FeatureActionUriEnable
config.xml
Description
It enables or disables the phone to receive action URI requests.
Permitted
Values
false - disable
true - enable
Default
false
Parameter
FeatureActionUriPromptEnable
config.xml
Description
It enables or disables the phone to pop up the Allow Remote Control prompt when
receiving action URI requests.
Permitted
Values
false - disable
true - enable
Default
true
Parameter
FeatureActionUriLimitIp
config.xml
Description
It configures server address from which the phone receives the action URI requests.
Multiple addresses are separated by commas. For discontinuous IP addresses, multiple IP
addresses are separated by commas.
For continuous IP addresses, the format likes *.*.*.* and the “*” stands for the values
0~255.
Note: It works only if “FeatureActionUriEnable” is set to true (Enabled).