ALE M3-M5-M7-M8 DeskPhones Administrator Guide
Settings → Time & Date → SNTP Address
It configures the IP address or the domain name of the NTP server2.
The IP phone will obtain the current time and date from the NTP server2
Settings → Time & Date → SNTP Secondary Address
It configures the interval (in seconds) at which the phone updates time and date from the
NTP server.
Settings → Time & Date → SNTP Refresh Period
11.6.3 DST Settings
You can set DST for the desired area as required. By default, the DST is disabled. If set to Automatic, it can
be adjusted automatically from the current time zone setting. The time zone and corresponding DST pre-
configurations exist in the AutoDST file. If the DST is set to Automatic, the IP phone obtains the DST
configuration from the AutoDST file.
11.6.3.1 DST Configuration
The following table lists the parameters you can use to configure DST.
It configures the Daylight Saving Time (DST) feature.
0 - Disabled
1 - Enabled
2 - Automatic
Settings → Time & Date → DST Enable
It configures the Daylight Saving Time (DST) Location.
Note: It works only if “SettingDstEnable” is set to 2 (Automatic).
Strings - country or area name
To Next Page
Loading...
