12.13.1 Hoteling Key Configuration
You can configure a line key as Hoteling key to log into the Hotel system.
On the phone, select one programmable key, long press it for 2s, and select Key Type as Hoteling.
The following shows configuration for a Hoteling Key.
<setting id="ProgramKey5Type" value="69"/>
<setting id="ProgramKey5Label" value="Hoteling"/>
12.13.2 Hoteling Configuration Parameters
The following table lists the parameters you can use to configure Hoteling function.
Note: X means account ID. It can be number 1~8 for M3/M5/M7, and 1-20 for M8.
It enables or disables the hoteling feature for account.
Note: It works only if “AccountXServerType” is set to 6 (Broadsoft).
It configures the password used to log into the guest for account.
Note: It works only if “AccountXServerType” is set to 6 (Broadsoft).
To Next Page
Loading...
