Alcatel-Lucent IP Touch 4068 - Set Leds; Connecting Optional Equipment; Headset

administrator. The system administrator can assign fixed features to these softkeys, such
as:
• Individual hold
• Trunk group presentation and supervision
• Out of service trunk supervision
• Directory number supervision
• Individual routing
• Speed dialing
• Network/network connection with supervision
• Call presentation
Important:
Call presentation is pre-programmed on key 1. Alcatel-Lucent recommends not to modify
this configuration. Another key may be used for the presentation of specific calls (VIP
calls or returning calls, when the call is chained, for example).
• Transfer with privilege
- Additional programmable keys. The attendant set may be expanded with add-on keypad
modules providing a maximum of 42 programmable keys. The available modules are the
Smart Display modules providing each one 14 keys associated to an electronic icon and
label. Each key can be programmed as a resource or supervision key. Some of these keys
may be locked by the system manager.
1.5 Set LEDs
The Alcatel-Lucent IP Touch 4068 Phone set LEDs are:
- An alarm LED located at the top right of the set display. The LED behavior is:
LED Color Signals
Green Normal call
Red Urgent call
- A message LED located on the key
- A mute LED located on the key. The mute LED flashes green when the set is
switched to mute mode (in both idle state and conversation state)
- A hands-free LED located on the key. The LED behavior is:
• The hands-free LED is lit (green) when the set is in hands-free mode or in forced
headset mode
• The LED flashes when the set is in group listening
• The LED is off in all other cases
1.6 Connecting Optional Equipment
1.6.1 Headset
Chapter
1
!$
1-10
    ! "       