This feature is used to interconnect two external callers via the installation, while retaining the
ability to release the connection.
When this feature is programmed by the system administrator, he/she can put the Net/Net key
on the main (perso) page or on the Smart Display Module.
3.8.1 Net/Net Key Present on the main (perso) Page
Following an incoming call, the attendant makes an outgoing call to a party. The first party is
automatically put on hold.
1. Press the key.
The next page is displayed
2. Press the left arrow on the navigator ( ).
The main (perso) page is displayed
3. In the main (perso) page, press the Net/Net key.
The two parties are connected and supervision is activated: the icon is on steady
4. Press the Net/Net key again.
The attendant barges in the conversation after a barge-in tone and the icon flashes
5. Press the Net/Net key again.
The attendant is back to supervision: the icon is on steady again
Once the connection is released, there is no icon next to the Net/Net label.
3.8.2 Net/Net Key Present on the Smart Display Module
Following an incoming call, the attendant makes an outgoing call to a party. The first party is
automatically put on hold.
1. Press the Net/Net key.
The two parties are connected and supervision is activated: the icon is on steady
2. Press the Net/Net key again.
The attendant barges in the conversation after a barge-in tone and the icon flashes
3. Press the Net/Net key again.
The attendant is back to supervision: the icon is on steady again
Once the connection is released, there is no icon next to the Net/Net label.
3.9 Trunk Group Supervision
This function allows the attendant to monitor the occupation level of a trunk group via a key,
present in the main (perso) page. The label of the key is the trunk group name.
Next to the trunk group name:
- There is no icon when there is still at least one trunk free in this trunk group
Chapter
3
$$ %!#
3-8
! "
To Next Page
Loading...
