2.8.1 Automatic/Manual Transfer
There are two transfer modes:
- Automatic transfer, which automatically transfers the call to a free user immediately after
dialing without other action
- Manual transfer, which requires an attendant action to transfer a call
To select the desired transfer operating mode, see Alcatel-Lucent IP Touch 4068 Attendant
Set - Management from the Attendant Set - Selecting Answer and Transfer Operating Modes
This manual only describes the manual transfer operating mode.
2.8.2 Transfer to a Busy Set
2.8.2.1 The Busy Set is Multiline (with a Free Line)
When the busy set dialing is complete, the screen displays:
Figure 2.46: Telephone Area Example (Internal Busy Set Number Dialed)
The following softkeys are available:
Transfer To transfer the first party to the busy set which can take the call on its
free line
Ring To activate ringing on the busy set while the first party is put on hold
Cancel To cancel the consultation call with the busy set and continue the conver-
sation with the first party.
Release To release both the conversation with the first party and the consultation
call with the busy set
Call back To send a callback request to the busy set while keeping the conversa-
tion with the first party
DTMF on To activate DTMF calling transparency. After having activated DTMF call-
ing transparency, DTMF off softkey is used to deactivate it
2.8.2.2 The Busy Set is a Single Line Set (or Multiline with All Lines Busy)
When the busy set dialing is complete, the screen displays:
#$ %!#
! "
2-27
To Next Page
Loading...
