Alcatel-Lucent IP Touch 4068 - Basic Features of the Alcatel-Lucent IP Touch 4068 Attendant Set; Putting the Attendant Set into Service; Methods for Calling Numbers

2.1 Putting the Attendant Set in Service
When the Alcatel-Lucent IP Touch 4068 Phone used as attendant set is powered up, at the
end of an initialization period, the screen displays the Attendant status page. This indicates
that the attendant is out of service.
Figure 2.1: Attendant Status Page
Press the Sign on softkey to put the attendant in service.
The Next page (see Alcatel-Lucent IP Touch 4068 Attendant Set - Introduction - next Page ) is
displayed.
2.2 Methods for Calling a Number
2.2.1 Direct Dialing
The attendant dials the user's number directly on the dialing keypad.
To reach an external number, the attendant first dials the external prefix before the external
number.
2.2.2 Calling via the Set Directory
The personal directory (see the Alcatel-Lucent IP Touch 4068 Attendant Set - Management
from the Attendant Set - Assigning Programmable Keys ) is used to select an internal (or
external) user via a softkey - without having to dial the full destination number.
Note 1:
The number called may be an internal, external, or speed dialing number.
Call by personal directory can be performed with the attendant set in idle state or when the
attendant set is already in conversation.
The main (perso) page or the add-on keypad modules if they exist, display the personal
directory entries already created.


 
    ! "       
2-1