Allen-Bradley ClutchBrake PLC-5 Series - Connect PLC Processors and Programming Terminal

6–7Install and Wire the Clutch/Brake Control System
Publication 65566.5.1 - October 1996
Connect PLC processors in chassis A and B with Belden 9463 cables,
and the programming terminal with a 1784-CP6 cable (Figure 6.6)
as follows:
Figure 6.6
Typical
Connections Between Processors
PLC5/46
in
Chassis A
Channel 1A for DH+ Link
Channel 1B for Remote I/O
Channel 1A DH+ to Programming Terminal
1784CP6 Cable
1
2
1
2
PLC5/26
in
Chassis B
(Belden 9463)
Configured for
Scanner Mode,
DH+ Station 0
Configured for
Adapter Mode,
DH+ Station 1,
Rack Addr. 02
Station 1
Rack 2
Clear
shield
Blue
For DH+ link connectors marked A :
Blue
shield
Clear
For remote I/O connectors
marked B :
150 ohm
termination
resistor
Station 0
A
A
B
B
Connect PLC Processors
and Programming
Terminal