Allen-Bradley ClutchBrake PLC-5 Series - Jumper and Switch Settings for I;O Chassis a and B; Keying the Backplane

6–4 Install and Wire the Clutch/Brake Control System
Publication 65566.5.1 - October 1996
Jumper and Switch Settings for
I/O Chassis A and B
Locate the jumper and switch assembly on the left-hand inside backplane
(Figure 6.3). Set them identically in chassis A and B.
Figure 6.3
Jumper
and Switch Settings for I/O Chassis A and B
Y
Leave jumper at the Y" (default) position
for the plugin power supply module.
Important: When using a power supply module, you cannot aug
ment power to the chassis with an external power supply.
ON
OFF
OFF
 RAM protected against writes and edits
 1slot addressing
 EEPROM does not transfer , processor faults
Important: Settings for chassis A and B
must be identical.
Set switches by pressing rocker arms.
Press in OFF side for off" and ON side for on".
OFF  Chassis outputs are turned off when fault is detected
 Always OFF
O N O
F F
1234 5678
OFF
OFF
ON
OFF
Keying the Backplane
Install keying bands, supplied with your I/O chassis, in numerical
locations so backplane slots will accept only the designated
processor or I/O module:
Leftmost Slots 0, 1 Slot 2 Slot 3 Slot 4 Slot 5
Processor Resolver 1771ID16 1771ID16 1771ID16 1771OD16
between:
40 and 42
54 and 56
Depends
on module.
See specs.
between:
10 and 12
14 and 16
between:
10 and 12
14 and 16
between:
10 and 12
14 and 16
between:
22 and 24
34 and 36