Description of Operating Modes A–3
Publication
65566.5.1 - October 1996
Single Stroke Mode
Single stroke mode is designed to stroke the press once, from top to
bottom to top, with the concurrent use of all active run buttons.
Once the press reaches the takeover cam (TCAM), operators can
release Run buttons without stopping the press it continues to the
near-top position.
During downstroke, releasing a Run button stops the press
(Figure A.2). To restart the press, press the Run buttons.
Once the press reaches the takeover cam, the press continues
automatically through the upstroke (Figure A.3).
If you purchased software with on-the-hop, you can start another
cycle without stopping the press if you release all Run buttons.
Then, press and hold Run buttons during the upstroke.
To Next Page
Loading...
