Chapter 6
Publication
65566.5.1 - October 1996
Install and Wire the
Clutch/Brake Control System
In this chapter, we assume that the press is ready for installation of
its control system. We help you install it with these steps:
• set jumpers and switches
• install PLC processors, I/O modules, and power supplies
• connect PLC processors and programming terminal
• wire ac power distribution to the controller
• convert controller OK relay contacts from N.O. to N.C.
• wire your control system
Important: Installing and/or checking other press functions such as
lubrication systems, slide adjustments, dies, cushions, counter
balances, and clamps, are beyond the scope of this chapter. We
encourage you to contact your press manufacturer for that
information.
We help you set jumpers and switches on these components:
• PLC-5/x6 processors
• 1771 I/O chassis A and B
• 1771-ID16 input modules
Output module, 1771-OD16, has no jumpers or switches.
Chapter Objectives
Set Jumpers and Switches
To Next Page
Loading...
