Allen-Bradley ClutchBrake PLC-5 Series - Page 100

6–2 Install and Wire the Clutch/Brake Control System
Publication 65566.5.1 - October 1996
PLC5/x6 Processors
You may set the DH+ station number (channel 1A) for PLC-5/46 and
PLC-5/26 processors respectively to 0 and 1 so they can communicate
(Figure 6.1). You may modify these switch settings if you application
requires it.
Figure 6.1
Setting
the DH+ Station Numbers with SW1
Rear View of PLC5 Processor
Switch Assembly SW1
Always OFF
Switch Side View
ON
OFF
=
=
Always OFF
Switch Side View
ON
OFF
=
=
PLC5/46 in Chassis A
DH+ Station Number = 0
PLC5/26 in Chassis B
DH+ Station Number = 1