8–9Test Your Clutch/Brake
Publication
65566.5.1 - October 1996
Singlestroke Mode
1. Select inch, and inch the press to the top.
2. Place the mode selector switch in single-stroke mode.
3. Press and hold Run buttons for more than 1/2 stroke.
4. Observe that the press cycles and stops on top.
5. Release the Run buttons and press again.
This time release Run buttons in the downstroke.
6. Observe that the press stops immediately.
7. Bring the press to top by pressing Run buttons and release in upstroke.
8. Repeat steps 3 and 4.
This time hold Run buttons for the entire cycle.
9. Observe that the press runs through one stroke and stops at the top.
Continuous Mode with Arm Continuous
1. Place the mode selector switch in continuous mode.
2. Press the Arm Continuous button.
3. Immediately press Run buttons, and release after downstroke.
4. Observe that the press continues to cycle.
5. Press the Stop-on-top button.
6. Observe that the press completes the cycle and stops on top.
7. Attempt to start the press (at step 3) but wait until after 5 seconds
(or until after the Arm-continuous timer has timed out) before
pressing Run buttons.
8. Observe that the press does not start.
9. Repeat steps 3 through 7.
To Next Page
Loading...
