Allen-Bradley ClutchBrake PLC-5 Series - Test Your Clutch;Brake Control System; Chapter Objectives; Static Wiring Tests; Controller OK Test

Chapter 8
Publication 65566.5.1 - October 1996
Test Your Clutch/Brake
Control System
Once you have completed the installation and programming of your
clutch/brake controller, test it to verify proper operation. We give
you the procedures in this chapter for the following:
• Static Wiring Tests
• Dynamic tests of operating modes
• Switch Tests
ATTENTION: Before starting this chapter, be sure that:
installation of all clutch/brake control hardware is complete
clutch/brake wiring is complete
control system is in compliance with all applicable standards
Otherwise, personal injury and/or property damage could result.
This section describes the following static wiring tests:
• Controller OK
• CRM
• Seal Relay
• Crowbar Relay
• Run Buttons
• Inch Buttons
• Stop-on-top Button
• Arm Continuous Button
• Mode selector Switch
• Valves and Valve Feedback
Controller OK Test
This is an internal test. The C/B software is designed to detect and
indicate a fault in the controller OK relay circuit should one occur.
See fault codes 003 and 083 in appendix C.
Chapter Objectives
Static Wiring Tests