Using This ManualP–2
Publication
65566.5.1 - October 1996
The last part of the manual contains appendices. Appendix A
contains these descriptions of control system operating modes:
• inch, and micro-inch
• single stroke
• continuous
Other appendices include:
• timing diagram of control system feedback, in Appendix B
• fault codes to help you debug the control system, in Appendix C
• operator prompts to help you run the press, in Appendix C
• class privileges and read/write access by class, in Appendix D
• reserved data files and program files, in Appendix E
• programming considerations for PLC-processors, in Appendix F
• wiring drawings for ungrounded ac power distribution, in Appendix G
• wiring drawings for grounded ac power distribution, in Appendix H
Wiring drawings are included on diskette so that you can modify
them with your own Computer Aided Drafting (CAD) system. They
are stored in these file formats:
• AutoCAD, Release 11.0 (.DWG)
• INTERCHANGE Software (.DXF)
Choose the one that matches your CAD system.
There are two sets of wiring drawings: one for ungrounded, the other for
grounded ac power distribution. Select the set you will use and dispose
of the other to avoid confusion.
We include fold-out wiring drawings in a separate package that
accompanies this manual, and a duplicate set in Appendices G and H.
We included both versions of Rockwell software on diskette:
• Series 6200
• Series AI5
Throughout the manual, we tell you the version of software that
applies to the software procedures.
Information in the
Appendices
We've Simplified Your
Wiring Documentation
Concerning Rockwell
Programming Software
To Next Page
Loading...
