3–3Customize the Wiring
Publication
65566.5.1 - October 1996
To customize the wiring drawings to suit your application:
1. Select the modifications that apply to your application from tables
on left-hand pages in this section.
2. Follow the instructions for the modification.
Some modifications require that you write ladder logic to replace
the function of the deleted wiring, or that you wire an input
terminal to a power rail.
3. Observe the corresponding example wiring diagram on the
right-hand page that results from making the modification.
We present instructions according to I/O module group because the
wiring for each I/O module group is presented on a separate drawing
in your set of wiring drawings.
Important: If using grounded ac power, skip to the next section.
ATTENTION: To guard against unexpected machine
operation with possible injury to personnel and/or machinery
damage, do not modify the wiring of system power
distribution (sheet 1 of 9) except as follows:
1. Deletion of crowbar relays.
2. Enter your own wiring in the
EMERGENCY STOP BY
CUSTOMER
zone 01-12 for such switches as:
E-Stop pushbuttons
die block
C/B air pressure
counterbalance air pressure
Generalized Instructions
to Customize Your Wiring
Customizing an
Ungrounded AC System
To Next Page
Loading...
