Allen-Bradley ClutchBrake PLC-5 Series - Options to Suit Your Application; Selecting Factory Configured Options; Programming Ladder Logic Commands

1–12 Overview of the Clutch/Brake Control System
Publication 65566.5.1 - October 1996
To customize the control system to suit your application, we help you:
• select your factory-configured options
• program your clutch/brake interface with ladder-logic commands
• wire your control system
Selecting Factory Configured Options
When you purchased your Application Package, you designated factory-
configured options by a coded catalog number (6556-Pxxxx) from
combinations of these features:
Order Code: Option: Lets You:
A
S
Method to
Start
Continuous
Mode
• for Armed Continuous: start continuous stroking by pressing the Arm
Continuous button and all active run buttons for at least 1/2 stroke. Or,
• for Strokeandahalf: start continuous stroking by holding run buttons into
the second stroke. If released before the second closure, the press comes
to a stop at the top; if after the second closure, the press keeps running
H or 0 On the Hop stroke the press in single mode without stopping by releasing and again
pressing run buttons when in the upstroke zone
P or 0 Active Pin include or exclude active pin wiring to detect the absence of a run station
K, M, M1, M3 Hardware Kit select PLC5/x6 processors, power supplies, and I/O for clutch/brake control
Programming Ladderlogic Commands
To customize the control system to your application, we help you program
any combination of the following command bits that interface to the
protected clutch/brake control program. See chapter 4.
To program this objective Use these command bits B151/
Simulate rotary cam limit switches
when using resolvers instead of RCLSs
brake monitor (BCAM)
takeover (TCAM)
antirepeat (ACAM)
00
01
02
Interface press and machine functions
during automatic continuous mode
permit cycle start
permit run
permit downstroke or delayed start
permit upstroke
top stop
permit inch
simulate inch buttons
simulate run buttons
arm for continuous on demand
inch output enabled
initiate automatic single stroke
03
04
05
06
07
08
09
25
27
28
29
Select operating mode remotely
with your ladder logic
remote inch mode
remote singlestroke mode
remote continuous mode
remote microinch mode
remote automatic singlestroke mode
10
13
14
24
26
Monitor clutch pressure and press motion clutch pressure ON
press in motion
motor running forward
11
12
18
Options to Suit
Your Application