Allen-Bradley ClutchBrake PLC-5 Series - Test Inch Buttons; Test Stop on Top and Arm Continuous Buttons; Test Mode Selector Switch

8–4 Test Your Clutch/Brake
Publication 65566.5.1 - October 1996
Test Inch Buttons
Test Inch-button wiring by observing input LEDS in Module Group 3.
Check the OK? box after verifying that the LED indication is correct.
For This Condition In Module Group 3
This Input LED is OFF
OK
?
In Module Group 3
This Input LED is ON
OK
?
Righthand Inch button pressed. Chassis B, Input 16 Chassis A, Input 15
Lefthand Inch button pressed. Chassis A, Input 16 Chassis B, Input 15
Left and Right Inch buttons not pressed Chassis A and B, Input 15 Chassis A and B, Input 16
Test Stopontop and Arm Continuous Buttons
Test the wiring of these buttons by observing input LEDS in Module
Group 3 for chassis A and B. Check the OK? box after verifying that
the LED indication is correct.
For This Condition In Module Group 3
This Input LED is OFF
OK
?
In Module Group 3
This Input LED is ON
OK
?
Stopontop not pressed N/A Input 14
Stopontop pressed Input 14 N/A
Arm Continuous not pressed Input 12 N/A
Arm Continuous pressed N/.A Input 12
Test Mode Selector Switch
Test the wiring of this switch by observing input LEDS in Module
Group 3 for chassis A and B. Check the OK? box after verifying that
the LED indication is correct.
For This Modeselect Position In Module Group 3
These Input LEDs are OFF
In Module Group 3
This Input LED is ON
OK
?
Off All of 6, 7, 10, 11, 12, 13, 14 Input 6
Inch
except for the input that Input 7
Single is turned ON. Input 10
Continuous Input 11
Remote Input 12
Microinch Input 13
Die Change Input 14