Allen-Bradley ClutchBrake PLC-5 Series - Page 101

6–3Install and Wire the Clutch/Brake Control System
Publication 65566.5.1 - October 1996
Leave the serial-port configuration for channel 0 at default for
RS-232C with SW2 (Figure 6.2) unless your application requires
RS-422A or RS-423.
Figure 6.2
Serialport
Setting with SW2
Front of
Processor
Front of
Processor
Bottom View of PLC5/26 Processor in Chassis BBottom View of PLC5/46 Processor in Chassis A
Switch Side View
ON
OFF
=
=
Same setting for both
(Default, RS232C)
Always OFF
Always OFF
Same setting for both
(RS422A)
Same setting for both
(RS423)