Allen-Bradley ClutchBrake PLC-5 Series - Page 48

3–6 Customize the Wiring
Publication 65566.5.1 - October 1996
I/O Module Group 3 (sheet 7 of 9) Ungrounded AC Power
For this modification Make these changes Then see
Delete run station 1
(You must have at least
one active run station)
1.Delete the right run station pushbutton switch wired to input terminal [ 1 ] for chassis A
and to input terminal [ 3 ] for chassis B.
2.Wire input terminal [ 1 ] for chassis A and input terminal [ 3 ] for chassis B to the
power rail 105L1 (wire high).
3.Delete the left run station pushbutton switch wired to input terminal [ 3 ] for chassis A
and to input terminal [ 1 ] for chassis B.
4.Wire input terminal [ 3 ] for chassis A and input terminal [ 1 ] for chassis B to the
power rail 105L2 (wire high).
5.Delete active pin wiring from input terminal [ 5 ] and from power rail 105L1
for chassis A and B.
Figure 3.5
Delete run stations
2, 3, and/or 4
(You must have at least
one active run station)
1.Delete the right run station pushbutton switch wired to input terminal [ 7 ], [15], or [23]
for chassis A and to input terminal [11], [17], or [25] for chassis B (respectively).
2.Wire input terminal [ 7 ], [15], or [23] for chassis A and input terminal [11], [17], or [25]
for chassis B (respectively) to the power rail 105L1 (wire high).
3.Delete the left run station pushbutton switch wired to input terminal [11], [17], or [25]
for chassis A and to input terminal [ 7 ], [15], or [23] (respectively) for chassis B.
4.Wire input terminal [11], [17], or [25] for chassis A and input terminal [ 7 ], [15], or [23]
for chassis B (respectively)to the power rail 105L2 (wire high).
5.Delete active pin wiring from input terminal [13], [21], or [27] and from power rail 105L1
for chassis A and B.
Figure 3.6
Delete active pin
(factoryconfigured
option)
If you ordered the factoryconfigured option of NO active pin:
1.Delete active pin wiring from input terminals [ 5 ], [13], [21], and [27] and from
power rail 105L1 for chassis A and B.
We deleted the wiring (Figure 3.6) and added the label (Reserved, Do Not Use).
Figure 3.6
Delete Arm Continuous
(factoryconfigured)
1.Remove the arm continuous switch and wiring at input terminal [37] in chassis A and B.
We deleted the wiring (Figure 3.7) and added the label (Reserved, Do Not Use).
Figure 3.7
Stop on top
Left/Right Inch
1.No modifications allowed. You must wire these inputs as shown on sheet 7 of 9 for the
control system to work correctly.
N/A