32 Rockwell Automation Publication 1756-UM022D-EN-P - May 2017
Chapter 2 Install the Controller
To configure RSLinx software to use a USB port, you need to first set up a
USB driver. To set up a USB driver, perform this procedure.
1. Connect your controller and workstation by using a USB cable.
2. On the Found New Hardware Wizard dialog box, click any of the
Windows Update connection options and click Next.
3. Click Install the software automatically (Recommended) and click
Next.
The software is installed.
TIP If the software for the USB driver is not found and the installation is
canceled, verify that you have installed RSLinx Classic software, version 2.59
or later.
To Next Page
Loading...
