Rockwell Automation Publication 1756-UM022D-EN-P - May 2017 41
Install the Controller Chapter 2
Use the Key Switch to Change the Operation Mode
The key switch on the front of the controller can be used to change the
controller to one of these modes:
• Program (PROG)
• Remote (REM)
• Run (RUN)
Figure 4 - Controller Key Switch
Use the Logix Designer Application to Change the Operation Mode
Depending on the mode of the controller you specify by using the key switch,
you can change the operation mode of the controller by using the Logix
Designer application.
After you are online with the controller and the controller key switch is set to
Remote (REM or the center position), you can use the Controller Status menu
in the upper-left corner of the Logix Designer application window to specify
these operation modes:
• Remote Program
• Remote Run
• Remote Test
OKFORCE SDRUN
Logix557x
R
U
N
R
E
M
P
R
O
G
To Next Page
Loading...
