EasyManua.ls Logo

Allen-Bradley GuardLogix 5570

Allen-Bradley GuardLogix 5570
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rockwell Automation Publication 1756-UM022D-EN-P - May 2017 157
Status Indicators Appendix A
I/O Fault Codes
I/O faults indicated by the controller are indicated on the status display in one
of these formats:
I/O Fault Local:X #XXXX message
I/O Fault ModuleName #XXXX message
I/O Fault ModuleParent:X #XXXX message
The first part of the format is used to indicate the location of the faulted
module. How the location is indicated depends on your I/O configuration and
the module’s properties specified in the Studio 5000 Logix Designer®
application.
The latter part of the format, #XXXX message, can be used to diagnose the
type of I/O fault and potential corrective actions. For details about each I/O
fault code, see the Logix5000 Major, Minor, and I/O Fault Codes
Programming Manual, publication
1756-PM014.
Code Message Code Message
#0001 Connection Failure #0115 Wrong Device Type
#0002 Insufficient Resource #0116 Wrong Revision
#0003 Invalid Value #0117 Invalid Connection Point
#0004 IOI Syntax #0118 Invalid Configuration Format
#0005 Destination Unknown #0119 Module Not Owned
#0006 Partial Data Transferred #011A Out of Connection Resources
#0007 Connection Lost #0203 Connection Timeout
#0008 Service Unsupported #0204 Unconnected Message Timeout
#0009 Invalid Attribute Value #0205 Invalid Parameter
#000A Attribute List Error #0206 Message Too Large
#000B State Already Exists #0301 No Buffer Memory
#000C Object Mode Conflict #0302 Bandwidth Not Available
#000D Object Already Exists #0303 No Bridge Available
#000E Attribute Not Setable #0304 ControlNet™ Schedule Error
#000F Permission Denied #0305 Signature Mismatch
#0010 Device State Conflict #0306 CCM Not Available
#0011 Reply Too Large #0311 Invalid Port
#0012 Fragment Primitive #0312 Invalid Link Address
#0013 Insufficient Command Data #0315 Invalid Segment Type
#0014 Attribute Not Supported #0317 Connection Not Scheduled
#0015 Data Too Large #0318 Invalid Link Address
#0100 Connection In Use #0319 No Secondary Resources Available
#0103 Transport Not Supported #031E No Available Resources
#0106 Ownership Conflict #031F No Available Resources
#0107 Connection Not Found #0800 Network Link Offline

Table of Contents

Other manuals for Allen-Bradley GuardLogix 5570

Related product manuals