48 Rockwell Automation Publication 1756-UM022D-EN-P - May 2017
Chapter 3 Configure the Controller
7. Choose the controller firmware major revision.
8. Choose the chassis size.
9. Choose the slot number.
The New Project dialog box displays the slot location of the safety
partner based on the slot number entered for the primary controller.
If you select a slot number for the primary controller that does not
accommodate placement of the safety partner immediately to the right
of the primary controller, you are prompted to re-enter a valid slot
number.
10. From the Security Authority pull-down menu, choose a security
authority option.
For detailed information on security, refer to the Logix5000™
Controllers Security Programming Manual, publication
1756-PM016.
11. If you want to use the selected protection for authentication and
authorization, check the box below Security Authority.
12. In the Description field, enter a description of the project.
13. Click Finish.
To Next Page
Loading...
