Allen-Bradley GuardLogix 5570

Rockwell Automation Publication 1756-UM022D-EN-P - May 2017 77
Add, Configure, Monitor, and Replace CIP Safety I/O Devices Chapter 5
3. Click Create.
4. Type a name for the new device.
5. To modify the Module Definition settings, click Change (if required).
6. Enter the node address for DeviceNet networks, or the IP address for
EtherNet/IP networks.
Only unused node numbers are included in the pull-down menu.
If your network uses network address translation (NAT), see
Set the IP
Address by Using Network Address Translation (NAT) on page 78.
7. To modify the Safety Network Number, click the button (if
required).
See page
79 for details.
8. Set the Connection Reaction Time Limit by using the Safety tab.
See page
79 for details.
9. To complete configuration of the safety I/O device, refer to its user
documentation and the Logix Designer application's online help.