Publication 1747-RM001G-EN-P - November 2008
13-60 SLC Communication Channels
Normal Polling Range
– High
0 Select the last slave station address to normal poll.
Normal Polling Range
– Low
255 Select the first slave station address to normal poll. Entering 255
disables normal polling.
Normal Poll Group
Size
0 Enter the quantity of active stations located in the normal poll range
that you want polled during a scan through the normal poll range
before returning to the priority poll range. If no stations are
configured in the Priority Polling Range, leave this parameter at 0.
Table 13.17 Define these parameters when configuring a SLC 5/03, 5/04, or 5/05 processor as a master station using standard
polling mode to communicate with slave stations (Continued)
Tab Parameter Default Selections
To Next Page
Loading...
