Rockwell Automation Publication 1783-UM007G-EN-P - February 2017 39
Get Started Chapter 2
Configure Network Settings
via Device Manager
To configure network settings via Device Manager after you run Express Setup,
follow these steps.
1. Access Device Manager, as described on
page 48.
If the Express Setup window does not appear, try the following:
• Verify that your network adapter is set to accept a DHCP address
• Enter the URL of a well-known website in your browser to be sure
that the browser is working correctly. Your browser then redirects to
Express Setup.
• Verify that any proxy settings or pop-up blockers are disabled on your
browser.
• Verify that any wireless interface is disabled on the computer.
2. On the Express Setup window, complete the fields, as described in
Table 11.
To view fields for Common Industrial Protocol (CIP), click Advanced
Settings.
To Next Page
Loading...
