Rockwell Automation Publication 1783-UM007G-EN-P - February 2017 107
Install Stratix 5410 Switches Chapter 4
Verify Switch Operation
Before installing the switch in its final location, power on the switch, and verify
that the switch powers up.
The time that is required for the switch to start up is directly related to your
switch configuration. Start time is negatively affected by such things as the
following:
• Spanning Tree Learning mode
• Number of files or images in onboard memory
To test the switch, follow these steps.
1. Apply power to the switch.
If the switch is directly connected to a power source, locate the circuit
breaker on the panel board that services the circuit. Switch the circuit
breaker to the On position.
2. Verify the start-up process.
When you power on the switch, it begins a start-up process. The Setup
status indicator blinks green as the IOS software image loads. If the
process fails, the Setup status indicator turns red.
3. After successfully running this test, do the following:
a. Turn off power to the switch.
b. Disconnect the cables.
c. Decide where you want to install the switch.
Mount the Switch on a Rack
To mount the switch on a rack, see the following:
•
Attach Brackets on page 108
•
Mount the Switch on page 110
IMPORTANT Start-up failures can be fatal to the switch. Contact your
Rockwell Automation representative immediately if your switch
does not complete the start-up process successfully.
IMPORTANT You can disable Boot Fast and run the Power-on self-test (POST) by
using the CLI. For more information, see the documentation at
http://www.Cisco.com.
To Next Page
Loading...
Need help?
General
