Rockwell Automation Publication 1783-UM003G-EN-P - December 2012 107
Manage the Switch via RSLogix 5000 Software Chapter 4
• Other Status Data
–Switch Internal Temperature: degrees Centigrade
–Power Supply A present: yes, no
–Power Supply B present: yes, no
–Identity Info: VendorID, DeviceType, ProductCode, ProductName,
Revision, SerialNumber
–IOS Release version
–Switch Uptime (since last restart)
–Management CPU Utilization: in %
–CIP Connection Counters: open/close requests, open/close rejects,
timeouts
–Port Alarm Status per port: OK, not forwarding, not operating, excessive
FCS errors
–Port Fault Status per port: Error Disable, SFP error, native VLAN
mismatch, MAC address flap condition, security violation
–Port Diagnostic Counters per port: Ethernet Interface counters (10),
Ethernet Media counters (12)
• Configuration Data (requires password)
–IP Address Method: DHCP, static
–IP Address, Subnet Mask, Default Gateway (all if static)
–Host Name
–Contact name
–Geographic Location
–Port Config per port: enable/disable, autonegotiate, forced speed/duplex
–Authorized MACID per port
–Unicast Storm Control Threshold per port: in packets per second, bits
per sec, or %
–Multicast Storm Control Threshold: in packets per second, bits per sec,
or %
–Broadcast Storm Control Threshold: in packets per second, bits per sec,
or %
• Smart Port assignment per port: Role and VLAN
• Save and Restore of Switch Configuration (via File Obj)
To Next Page
Loading...
