Chapter 16: SNMPv1 and v2c
216
SNMP Community Strings
A community string has attributes for controlling who can use the string
and what the string will allow a network management station to do on the
switch. The AT-S114 Management Software does not provide any default
community strings. You must first define an SNMP User and Group Name
on the SNMP User/Group page and then define a Community Name on
the SNMP Community Table page.
Use the following sections to create, modify, and delete SNMP community
strings:
“Create SNMP Community Strings,” next
“Modify SNMP Community Strings” on page 217
“Delete SNMP Community Strings” on page 217
Create SNMP
Community
Strings
To create an SNMPv1 or SNMPv2c community string, do the following:
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Community Table.
The Community Table Page is displayed. See Figure 79.
Figure 79. Community Table Page
3. Enter a new Community Name.
A name can be up to 32 characters in length.
4. Enter a User Name(View Policy) that has been previously defined.
To Next Page
Loading...
Need help?
General
