Chapter 18: Access Control Configuration
252
5. Click Add.
The rate control entry is displayed at the bottom of the table. If you do
not see your new entry, you may need to navigate to another page of
the table with the First Page, Previous Page, Next Page, and Last
Page buttons located below the table. An example of a rate control
entry is shown in Figure 98.
Figure 98. Rate Control Settings Example
6. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
Modify the
Committed Rate
To modify the committed rate for a rate control entry, perform the following
procedure:
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.
2. From the Access Control Config folder, select Rate Control
Settings.
The Rate Control Settings page is displayed. An example of the page
with an entry is shown in Figure 98.
3. From the Rate Control page, identify which committed rate entry
whose rate you want to modify and enter the new rate in the 64kbps x
field in the Committed Rate column.
4. Click the Apply button in the Action column.
5. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
To Next Page
Loading...
Need help?
General
