BIBI 850-BL Use and maintenance manual Rev.00
25
2.5 Transport and loading
You are advised to check the dimensional limits established for means of transport if the machine must
be transported to its specific work site (see sect. 1.6-Performance).
The machine can be loaded onto the vehicle in two different ways:
1) Using chutes and the platform movement commands: with the platform completely LOWERED,
the operator can move the machine by following the instructions in PAR. 4.3-STARTING and drive
the machine straight onto the vehicle. In this case, make sure that the ramp gradient is within the
gradeability indicated in the PERFORMANCE data and that the bearing capacity of the chutes suits
the weight of the machine.
Note: the machine has an advanced traction control "Direction-Control" (DC-S on the control panel)
that lets you move in a straight line using a single joystick. We recommend using this operating move
with the platform in track width and after having aligned the chutes (ref. Par. 4.2.7)
2) Removing the pushbutton panel from the base and driving the platform on the ground: with
the platform in the transport position, the operator can move the machine directly from the ground
using the portable pushbutton panel and following the instructions in PAR. 4.3 - DRIVING FROM
THE GROUND WITH THE MOBILE PUSHBUTTON PANEL (see photo below).
To Next Page
Loading...