EasyManua.ls Logo

ALMAC BiBi 850-BL - 2.9 Maintenance Safety

ALMAC BiBi 850-BL
127 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BIBI 850-BL Use and maintenance manual Rev.00
32
2.9 Safety regulations during maintenance
The maintenance operations described in this Manual refer to platforms in conditions of normal use. In
heavy duty use conditions (e.g. extreme temperatures, dust and corrosive substances in the
environment, etc…), inform the ALMAC S.r.l. assistance services to have the maintenance intervals
checked and changed.
The MAINTENANCE operations must only be performed by authorized and adequately trained
personnel.
Only perform the MAINTENANCE and ADJUSTMENT operations described in this Manual. Contact
the ALMAC S.r.l. assistance service only, if other operations are required (e.g. if faults occur).
All MAINTENANCE work must be performed in compliance with the laws in force governing safety
and protection of the environment.
THE MANUFACTURER IS RELIEVED FROM ALL LIABILITY FOR ACCIDENTS OR FAULTS
DUE TO FAILURE TO COMPLY WITH THE RECOMMENDATIONS AND SAFETY
REGULATIONS.
Maintenance must only be carried out after the emergency push-button has been pressed and the
engine turned off.
Before proceeding with the interventions, make sure the platform is completely blocked.
If the basket must be raised for maintenance purposes, the platform and lifting structure must be
prevented from accidentally lowering. To do this, there is a device on the lift arm that must be set
in a precise position so as to immobilize the scissor structure (see procedure described below).
Take care of the environment: avoid spilling oil when changing it or topping up.
Used oil must be disposed of in accordance with the laws in force.
Never insert the body, limbs or fingers in sharp, jointed opening on the machine
that is not controlled or without proper guards unless securely blocked.
Never use petrol, solvents or other flammable liquids as detergents: use the
authorized, non-flammable, non-toxic solvents available from the market.
Do not use open flames for lighting purposes when performing maintenance.
Make sure that there are no fluids under pressure before disassembling unions or
pipes: Immediately call a physician if injuries occur or the fluid from pipes is
accidentally ingested. Remember that fluid seeping from a very tiny hole can be

Table of Contents