BIBI 850-BL Use and maintenance manual Rev.00
56
4.1.5 Combustion engine starting
To start the combustion engine and the hydraulic pumps, use the key on the ground controls
(17). Before starting, perform the inspections described in sect. 2.6- Inspections before use.
The key-switch functions are:
(CENTRAL): Machine off-electrical system not powered
(RIGHT): The platform's entire electrical system starts, including the mobile pushbutton
panel in the basket. The ground controls are excluded.
(LEFT): The platform's entire electrical system starts. The ground controls are enabled and
the basket pushbutton panel is automatically disabled.
This is followed by a check-control of the indicator lights of the safety system, which flash as
described below:
- Indicator light (2): Maximum inclination reached
- Indicator light (5): Basket overloaded
If one or more of the indicators fails to flash, it means that the relative light bulb must be
changed.
Once the check-control cycle has terminated, the engine can be started by pressing the related
lever (5).
Before climbing in the basket:
1. Remove the key from the ground control panel and take it with you:
2. Make sure that the fuel supply lever is in the ON position (see figure to the side)
3.
FUEL
VALVE LEVER
ON
To Next Page
Loading...