BIBI 850-BL Use and maintenance manual Rev.00
57
Starting the motor in harsh conditions (e.g., during winter months) is ensured by an electronic
fuel injection system.
4.1.6 Emergency starting
If the platform cannot be started as illustrated in the previous section, proceed in the manual
mode as described below.
1) With the platform fully lowered, turn on the electric panel on the console using the key-
switch (17), then move to the combustion engine;
2) Take hold of the hand lever and pull it strongly (see photo below). You may have to do this
several times before the engine starts.
4.1.7 Electric motor starting
To start the electric motor and thus the related hydraulic pumps, first connect a sufficiently long
cable with three-pole socket that complies with European standard IEC 309 (see photo below)
to the socket located near the access ladder.
The electrical power characteristics MUST be as follows:
Voltage: 220 V / 50 Hz
En
gine hand-starter lever
Type of electrical socket to use for
mains hookup
Socket location
To Next Page
Loading...