BIBI 850-BL Use and maintenance manual Rev.00
58
Power required: 2.2 kW
Then turn the ignition key in the ground controls (17) to the RIGHT position. Before starting,
perform the inspections described in sect. 2.6- Inspections before use.
This is followed by a check-control of the indicator lights of the safety system, which flash.
Once this phase is complete, turn the switch (6) on the control panel to the "ELECTRIC
ENGINE" position. This enables the electric motor startup up and supply of 220V to the socket
in the basket.
To stop or start the electric motor, set the "ON" lever (5) in the control panel:
Attention: During operation with the INTERNAL COMBUSTION ENGINE, the 220V socket can be
attached to the plug and the switch (6) can be turned to the OUT 220V position. This makes it possible
to use the electricity in the 220V socket in the basket.
To Next Page
Loading...