BIBI 850-BL Use and maintenance manual Rev.00
83
In these cases, the valve must be calibrated by SPECIALIZED PERSONNEL according to the
monitoring procedure described above. Using the appropriate tools, unscrew the lock nut (1) and tighten
or loosen the adjuster screw (2) until the indicated pressure level has been reached. Once the
adjustments have terminated, tighten the lock nut (1) to hold the screw in position.
Dia
gram of the pressure relief valve
Attention: Calibration operation must only be performed by SPECIALIZED personnel. It must
not be done by a generic operator.
6.9 Battery
6.9.1 General recommendations
The battery is an essential component for machine operation. It is important to ensure that it
remains in a good condition over time since this will lengthen its working life, limit any
problems that may arise and reduce the running costs of the machine.
Comply with the following instructions:
☼ CHARGE THE BATTERY IN A VENTILATED PLACE AND OPEN THE VENT CAPS
TO ALLOW THE GAS TO ESCAPE DURING THE CHARGING OPERATION
☼ KEEP OPEN FLAMES WELL AWAY FROM THE BATTERY SINCE EXPLOSIVE
GASES COULD FORM
☼ DO NOT MAKE TEMPORARY ELECTRICAL CONNECTIONS OR ONES THAT FAIL
TO COMPLY WITH THE REGULATIONS
☼ DO NOT PLACE TOOLS OR ANY OTHER METAL OBJECT ON THE BATTERY
☼ CLEAN ANY ENCRUSTATIONS FROM THE BATTERY TERMINALS AND
ALWAYS TIGHTEN THEM CORRECTLY
To Next Page
Loading...