EasyManuals Logo

Amazone AMATRON 3 Operating Manual

Amazone AMATRON 3
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Commissioning the GPS application
AMATRON
3 BAG0094.6 02.15
57
10.2.1 Degree of overlap
When working, it is possible that areas of a part
width will be covered that have already been
tilled or are not supposed to be tilled.
The degree of overlap specifies whether the
corresponding part width section is switched
during this process.
Degree of overlap 0 %:
As soon as there is overlap, the corre-
sponding part width section is switched off.
Degree of overlap 50 %:
As soon as 50 % of a part width section
overlaps, the part width section is switched.
Recommendation for fertiliser spreaders!
Degree of overlap 100 %:
The part width section is not switched off
until there is complete overlap of a part
width section.
For field sprayer and fertiliser spreaders:
At the border, work is always carried out with a
degree of overlap of 0%.
Only for seed drills:
Degree of overlap of 100 % is recommended.

Table of Contents

Other manuals for Amazone AMATRON 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Amazone AMATRON 3 and is the answer not in the manual?

Amazone AMATRON 3 Specifications

General IconGeneral
BrandAmazone
ModelAMATRON 3
CategoryTouch terminals
LanguageEnglish

Related product manuals