12.5 Setup GPS switch (GPS track)
In the Work menu: .
ο
Straight connection line guide
pattern or any contour between points
A and B.
ο
, Beds.
ο
Lead track spacing
The working width of the implement as
standard. To ensure an overlapping,
the value can be somewhat reduced.
ο
, Set the sensitivity of the
light bar in cm.
→
, , see page 55.
Parallel travel
The lead tracks are parallel lines:
• AB → The lead tracks are straight, parallel lines to connect the
set points A and B.
• A+ → The lead tracks are straight, parallel lines established by
points A and B. and an angle in which the lead tracks should
run.