Amazone AMATRON 3 Operating Manual

Use of the GPS switch application
74
AMATRON 3 BAG0094.6 02.15
11.3 Automatic mode and manual mode
The GPS switch application can be used both in manual and auto-
matic mode.
In automatic mode, switching the part width sections is automatic
both in the field and in the headland.
Automatic mode:
• Automatic switching on/off
Manual mode:
• No automatic boom section control.
• Operation of the machine via implement control, Joystick,
AMACLICK
.
• Only display and marking on the terminal.
ISOBUS:
Section Control always starts in the mode in which it was exited.
Automatic mode remains after
• Switching on the control terminal,
• Starting a new job
• GPS failure
→ If necessary, operate Section Control through the implement
software.
AMABUS:
Section Control always starts in manual mode.
Automatic mode
1. Move the implement into working position.
2.
Select the GPS switch application.
3.
Select the GPS switch work menu.
4.
Select automatic mode.
5.
Select implement control application.
6. ISOBUS: if necessary, set Section Control to automatic in the
implement control.
7. If necessary, switch on the implement
8. Start up and begin work.
→ Part width sections are switched automatically.
→
Worked area is shown in the GPS switch work menu.

Amazone AMATRON 3 Specifications

General

Brand	Amazone
Model	AMATRON 3
Category	Touch terminals
Language	English