Ametek 241CE II

Installation and Start-Up | 3-1
INSTALLATION and START-UP
This chapter describes how to install and start up the Model 241CE II
Hydrocarbon Dewpoint Analyzer, including:
• Safety requirements to consider before working on the analyzer.
• Uncrating, inspecting, and storing the analyzer prior to installation.
• Installing the mechanical components and making the electrical con-
nections.
• Powering up the Model 241CE II HCDP Analyzer and performing
start-up checks and adjustments.
• Performing a sample system leak check.
The installation of the analyzer must be in accordance with all of the
end user and local regulatory standards and procedures. There are no
operator-serviceable components inside the analyzer. Refer servicing
to qualified personnel.
!
WARNING