3-42 | Model 241CE II Hydrocarbon Dewpoint Analyzer
Analyzer Conguration
EEPROM Data Sheets and Dewpoint Monitor Data Sheets which list the fac-
tory default configuration settings of all programmable parameters are
located in the analyzer Documentation Package.
IMPORTANT
Keep these forms in a safe place and record any changes you make to
the original factory settings for later reference. If the EEPROM is
replaced, this data must be re-entered in order to override the factory
defaults.
The analyzer’s serial number, firmware version, and operating voltage
cannot be set or changed in the field. If necessary, see the original configu-
ration sheets to revert the analyzer back to its original settings.
The Model 241CE II Analyzer is pre-configured at the factory, ac-
cording to predetermined and agreed upon customer requirements.
However, if changes are required, most parameters can be changed.
See Chapter 4 for more information about navigating through the
menus from the User Interface.
NOTE
NOTE
To Next Page
Loading...
Need help?
General
